Chapter 3 Ipx Configuration Commands; Ipx Configuration Commands; Display Ipx Interface - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide — IP / IPX

Chapter 3 IPX Configuration Commands

3.1 IPX Configuration Commands

3.1.1 display ipx interface

Syntax
display ipx interface [Vlan-interface vlan-id ]
View
Any view
Parameter
vlan-id: Specifies a VLAN interface by specifying its VLAN ID.
Description
Use the display ipx interface command to view the IPX information of the specified
VLAN interface.
If no vlan-id is specified, the IPX information of all the IPX-enabled VLAN interfaces
will be displayed.
Example
# View the IPX information of VLAN interface 1.
<3Com> display ipx interface Vlan-interface 1
Vlan-interface1 is down
IPX address is 1.0020-9c68-448e [down]
SAP is enabled
Split horizon is enabled
Update change only is disabled
Forwarding of IPX type 20 propagation packet is disabled
Delay of this IPX interface, in ticks is 1
SAP GNS response is enabled
RIP packet maximum size is 432 bytes
SAP packet maximum size is 480 bytes
IPX encapsulation is Netware 802.3
0 received, 0 sent
0 bytes received, 0 bytes sent
0 RIP received, 0 RIP sent, 0 RIP discarded
0 RIP specific requests received, 0 RIP specific responses sent
Chapter 3 IPX Configuration Commands
3-1