Adding An Egress Source Port; Deleting An Egress Source Port; Managing Ingress Source Ports - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
If egress source ports have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config switch port-mirroring egress-src
switch port-mirroring
egress-src lm1 1
!
!
If no egress source ports have been configured, add egress source ports as needed. For more information, refer
to Section 5.16.2.2, "Adding an Egress Source
Section 5.16.2.2

Adding an Egress Source Port

To add an egress source port for port mirroring, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the egress source port by typing:
switch port-mirroring egress-src slot port
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.16.2.3

Deleting an Egress Source Port

To delete an egress source port for port mirroring, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the address by typing:
no switch port-mirroring egress-src slot port
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.16.3

Managing Ingress Source Ports

The following sections describe how to configure and manage ingress source ports for port mirroring:
• Section 5.16.3.1, "Viewing a List of Ingress Source Ports"
• Section 5.16.3.2, "Adding an Ingress Source Port"
• Section 5.16.3.3, "Deleting an Ingress Source Port"
266
Port".
RUGGEDCOM ROX II
CLI User Guide
Adding an Egress Source Port