Show Firewall Rule Config-Check - Allied Telesis AT-AR3050S Command Reference Manual

F C
IREWALL OMMANDS
-
SHOW FIREWALL RULE CONFIG CHECK

show firewall rule config-check

Overview Use this command to check configuration validity of firewall rules.
An invalid rule will not be active and cannot be hit. This command also shows the
reasons why a rule is not valid.
Syntax show firewall rule config-check
Mode Privileged Exec
Usage Firewall rules are applied to applications and entities. A rule is not valid if either the
application, source entity or destination entity the rule applies to is not configured
properly.
To configure applications and entities, see Application and Entity Commands.
Examples To check configuration validity of firewall rules, use the command:
awplus#
Output Figure 45-6: Example output from the show firewall rule config-check
Output Figure 45-7: Example output from the show firewall rule config-check
Related rule (Firewall)
commands
show firewall rule
C613-50077-01 REV A
show firewall rule config-check
command if rule configuration errors are detected
awplus#show firewall rule config-check 
Rule 10: 
Application does not have a protocol configured 
"From" entity does not exist 
"To" entity has no subnet or host addresses 
command if all rules are valid
awplus#show firewall rule config-check 
All rules are valid 
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
2110