D-Link DXS-3600 Series Cli Reference Manual page 160

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
By default, the BGP router does not consider router ID of the routes when comparing paths that have
identical comparing factors. Use this command to include router ID in comparison of paths that have
identical comparing factors.
Example
This example shows how to configure to compare router-id for identical eBGP paths for autonomous
system 65534.
Switch# configure terminal
Switch(config)# router bgp 65534
Switch(config-router)# bgp bestpath compare-router-id
11-9 bgp bestpath med confed
This command is used to configure a BGP routing process to compare the Multi Exit Discriminator (MED)
between paths learned from confederation peers. Use the no form of the command to disable MED
comparison of paths received from confederation peers.
bgp bestpath med confed
no bgp bestpath med confed
Parameters
None.
Default
By default, MEDs are not compared between paths from confederation peers.
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
If enabled, the BGP process will compare the MED for the routes that are received from confederation
peers. For routes that have an external AS in the path, the comparison does not occur.
Example
This example shows how to configure the BGP process 10000 to compare MED values for paths learned
from confederation peers.
Switch# configure terminal
Switch(config)# router bgp 10000
Switch(config-router)# bgp bestpath med confed
155