Basic Ipv6 Commands - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
9.

Basic IPv6 Commands

9-1 clear ipv6 neighbors
This command is used to clear IPv6 neighbor cache dynamic entries.
clear ipv6 neighbors {all | INTERFACE-ID}
Parameters
all
INTERFACE-ID
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
This command will only clear dynamic neighbor cache entries.
Example
This example shows how to clear IPv6 neighbor cache entries associated with interface VLAN 1:
Switch# clear ipv6 neighbors vlan1
Switch#
9-2 ipv6 address
This command is used to manually configure an IPv6 addresses on the interface. Use the no form of the
command to delete a manually configured IPv6 address.
ipv6 address {IPV6-ADDRESS/PREFIX-LENGTH | PREFIX-NAME SUB-BITS/PREFIX-LENGTH |
IPV6-ADDRESS link-local}
no ipv6 address {IPV6-ADDRESS/PREFIX-LENGTH | PREFIX-NAME SUB-BITS/PREFIX-LENGTH |
IPV6-ADDRESS link-local}
Parameters
IPV6-ADDRESS
PREFIX-LENGTH
Specifies to clear the dynamic neighbor cache entries associated with
all interfaces.
Specifies to clear dynamic neighbor cache entries associated with the
specified interface will be cleared.
Specifies the IPv6 address and the length of prefix for the subnet.
Specifies the length of the prefix. The prefix of the IPv6 address is also
a local subnet on the interface.
127