D-Link DXS-3600 Series Cli Reference Manual page 143

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
9-15 ipv6 nd reachable-time
This command is used to configure the reachable time used in the ND protocol. Use the no form of the
command to revert to the default setting.
ipv6 nd reachable-time MILLI-SECONDS
no ipv6 nd reachable-time
Parameters
MILLI-SECONDS
Default
The default value advertised in RA is 1200000.
The default value used by the router is 1200000 (1200 seconds).
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The configured time is used by the router on the interface and is also advertised in the RA message. If
the specified time is 0, the router will use 1200 seconds on the interface and advertise 1200 (unspecified)
in the RA message. The reachable time is used by the IPv6 node in determining the reachability of the
neighbor nodes.
Example
This example shows how to configure the reachable time on VLAN 1 to 3600 seconds.
Switch# configure terminal
Switch(config)# interface vlan1
Switch (config-if)# ipv6 nd reachable-time 3600000
Switch (config-if)#
9-16 ipv6 nd ns-interval
This command is used to specify the interval between retransmissions of NS messages. Use the no form
of the command to revert to the default setting.
ipv6 nd ns-interval MILLI-SECONDS
no ipv6 nd ns-interval
Parameters
MILLI-SECONDS
Specifies the IPv6 router advertisement reachable time range in
milliseconds. This value must be between 0 and 3600000 milliseconds,
in multiples of 1000.
Specifies the amount of time between retransmissions of NS message
138