D-Link DXS-3600 Series Cli Reference Manual page 116

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
7-26 server (RADIUS)
This command is used to associate a RADIUS server host with a RADIUS server group. Use the no form
of the command to remove a server host from the server group.
server {IP-ADDRESS | IPV6-ADDRESS}
no server {IP-ADDRESS| IPV6-ADDRESS}
Parameters
IP-ADDRESS
IPV6-ADDRESS
Default
By default, no server is configured.
Command Mode
RADIUS Group Server Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to enter the RADIUS group server configuration mode. Use the server command to
associate the RADIUS server hosts with the RADIUS server group. The defined server group can be
specified as the method list for authentication, or accounting via the aaa authentication and aaa
accounting commands. Use the radius-server host command to create a server host entry. A host entry
is identified by IP Address.
Example
This example shows how to create two RADIUS server hosts with the different IP addresses. A server
group is then created with the two server hosts.
Switch#configure terminal
Switch(config)# radius-server host 172.19.10.100 auth-port 1500 timeout 8 retransmit 3
key ABCDE
Switch(config)# radius-server host 172.19.10.101 auth-port 1600 timeout 3 retransmit 1
key ABCDE
Switch(config)#aaa group server radius group1
Switch(config-sg-radius)# server 172.19.10.100
Switch(config-sg-radius)# server 172.19.10.101
Switch(config-sg-radius)#
7-27 server (TACACS+)
This command is used to associate a TACACS+ server with a server group. Use the no form of the
command to remove a server from the server group.
server IP-ADDRESS
no server IP-ADDRESS
Specifies the IPv4 address of the authentication server.
Specifies the IPv6 address of the authentication server.
111