D-Link DXS-3600 Series Cli Reference Manual page 109

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
default
METHOD-LIST
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
For accounting via the method list to take effect, enable AAA first by using the aaa new-model command.
Create the method list first by using the aaa accounting exec command. If the method list does not exist,
the command does not take effect.
Example
This example shows how to specify that the method configured for AAA should be used for accounting for
HTTP server users. The AAA accounting method is configured as the RADIUS accounting method.
Switch# configure terminal
Switch(config)# aaa accounting exec list-1 start-stop group radius
Switch(config)# ip http accounting exec list-1
Switch(config)#
7-18 ip radius source-interface
This command is used to specify the interface whose IP address will be used as the source IP address
for sending RADIUS packets. To revert back to the default setting, use the no form of this command.
ip radius source-interface INTERFACE-ID
no ip radius source-interface
Parameters
INTERFACE-ID
Default
The IP address of the closest interface will be used.
Command Mode
Global Configuration Mode.
Server Group Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Specifies to do accounting based on the default method list.
Specifies the name of the method list to use.
Specifies the interface whose IP address will be used as the source IP
address for sending RADIUS packets.
104