D-Link DXS-3600 Series Cli Reference Manual page 126

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12,15.
Usage Guideline
Use this command to enable the local proxy ARP function on an interface. This command is used in the
primary VLAN of a private VLAN domain to enable routing of packets among secondary VLANs or
isolated ports within the domain. The command only take effects when ip proxy arp is enabled.
Example
This example shows how to enable local proxy ARP on VLAN100.
Switch# configure terminal
Switch(config)# interface vlan100
Switch(config-if)# ip local-proxy-arp
Switch(config-if)#
8-7 ip arp elevation
This command is used to assign a higher priority to all ARP packets to this switch than other ARP packets.
ip arp elevation
no ip arp elevation
Parameters
None.
Default
By default, all ARP packets have the same priority.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to assign a higher priority to all ARP packets to this switch than other ARP packets.
Example
This example shows how to enable IP ARP elevation.
Switch# configure terminal
Switch(config)# ip arp elevation
Switch(config)#
8-8 ip mtu
121