D-Link DXS-3600 Series Cli Reference Manual page 111

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config)# ip tacacs source-interface vlan100
Switch(config)#
7-20 ip vrf forwarding (server-group)
This command is used to configure the VRF reference of an authentication, authorization, and accounting
(AAA) RADIUS or TACACS+ server group, use the ip vrf forwarding command in the server group
configuration mode. To enable server groups to use the global (default) routing table, use the no form of
this command.
ip vrf forwarding VRF-NAME
no ip vrf forwarding
Parameters
VRF-NAME
Default
Server groups use the global routing table.
Command Mode
Server Group Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to specify a VRF for an AAA RADIUS or TACACS+ server group. This command
enables access users to utilize AAA servers in different routing domains.
Example
This example shows how to specify the VRF for a RADIUS server group.
Switch#configure terminal
Switch(config)#aaa group server radius_global
Switch(config-sg-radius)#server 172.16.10.254
Switch(config-sg-radius)#exit
Switch(config)#
Switch(config)#aaa group server radius_sales
Switch(config-sg-radius)#server 10.10.0.1
Switch(config-sg-radius)#ip vrf forwarding sales
Switch(config-sg-radius)#
7-21 ipv6 radius source-interface
This command is used to specify the interface whose IPv6 address will be used as the source IPv6
address for sending RADIUS packets. To revert back to the default setting, use the no form of this
command.
ipv6 radius source-interface INTERFACE-ID
Specifies the name of the Virtual Routing and Forwarding (VRF) entry.
106