Applicable Version; Starting And Aborting Printing; Start And Abortion By Triggers; Start And Abortion By Touch Switches - Mitsubishi Electric F930GOT-BWD Operation Manual

Graphic Operation Terminal GOT-F900
16.2

Applicable version

GOT
Product model name
F930GOT
F940, F943GOT
F940WGOT
To use this additional function, the following versions of the screen creation software are
required.
Screen creation software
Software name
GT Designer
FX-PCS-DU/WIN-E
16.3

Starting and aborting printing

16.3.1

Start and abortion by triggers

Printing start/abort command is given when a corresponding bit device in the PLC specified in
the screen creation software turns ON. The GOT monitors in a constant cycle whether these
bit devices have turned ON (monitoring cycle).
The monitoring cycle can be set in the unit of 1 second within the range from 1 to 60 seconds.
* If the bit device ON period is shorter than the monitoring cycle, it may not be recognized as
a trigger. Make sure that the ON period is longer than the monitoring cycle.
(Refer to program example shown in 16.3.3.)
16.3.2

Start and abortion by touch switches

Printing can be started and aborted by pressing touch switches.
Assign the following key codes to the touch switches.
Key code
Not possible to use
V2.00 or later
V1.00 or later
Applicable version
SW1D5C-GOTR-PACK(H) or later
V2.00 or later
Start Abort
FF17 FF18
Version
Screen Hard Copy Function 16
16-2