Table of Contents
Advertisement
P
C
C
LUGGABLES AND
ABLING
OMMANDS
-
SHOW SYSTEM FIBER
MONITORING
show system fiber-monitoring
Overview
Use this command to display settings and current status for Active Fiber
Monitoring.
show system fiber-monitoring
Syntax
Mode
User Exec/Privileged Exec
Example
To display configuration and status for active fiber monitoring on ports, use the
command:
awplus#
Output
Figure 7-2:
C613-50103-01 REV A
show system fiber-monitoring
Example output from show system fiber-monitoring
awplus#show sys fiber-monitoring
Fiber Monitoring Status
Reading units 0.0001mW
Stack member 1:
Interface port1.0.1
Status:
enabled
Supported:
Supported pluggable
Debugging:
disabled
Interval:
2 seconds
Sensitivity:
1.00dB
Baseline type:
average of last 35 values greater than 50
Status:
Baseline value:
Alarm threshold:
Alarm:
Last 12 Readings: 498 498 498 498 498 498 498 498 498 498 498 498
Minimum reading: 486
Maximum reading: 498
Interface port1.0.2
Status:
enabled
Supported:
Supported pluggable
Debugging:
disabled
Interval:
2 seconds
Sensitivity:
1.00dB
Baseline type:
average of last 30 values greater than 50
Status:
Baseline value:
Alarm threshold:
Alarm:
Last 12 Readings: 0 0 0 0 0 0 0 0 0 0 0 0
Minimum reading: 0
Maximum reading: 0
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
496
393
no
0
0
no
292
Advertisement
Table of Contents
