Stack Renumber; Switch Provision - Allied Telesis SwitchBlade x908 GEN2 Installation Manual

Chapter 6: Configuring Switches for Stacking
STACK
RENUMBER
SWITCH
PROVISION
152
stack switch_ID priority priority_number
The variables are defined here:
 switch_ID - This is the ID number of the switch. The range is 1 to 8.
You can specify only one ID number.
 priority_number - This is the new priority number for the switch.
You can specify only one number. The range is 0 to 255. The
default is 128.
This example assigns the priority 1 to the switch with ID 1:
awplus(config)# stack 1 priority 1
This example assigns the priority 2 to the switch with ID 2:
awplus(config)# stack 2 priority 2
Every switch in a stack has to have a unique ID number. The range is 1 to
4. The default is 1. The master switch will use the default value. The value
is set with this command. You use this command in the following
procedures to set the ID numbers of the member switches. Here is the
command format.
stack current_switch_ID renumber new_switch_ID
The variables are defined here:

current_switch_ID - This is the current ID number of the switch.
You can specify only one ID number. The default is 1.
 new_switch_ID - This is the new ID number for the switch. You can
specify only one number. The range is 1 to 8. The default is 1.
Changing the ID number requires resetting the switch.
This example changes the switch's ID from the default ID 1 to 2:
awplus(config)# stack 1 renumber 2
To ensure that the first power-on of the stack is successful, Allied Telesis
recommends configuring the units such that the units know about each
other prior to forming the stack. This involves using the SWITCH
PROVISION command to add the member switches as provisioned units
on the master, and the master switch as a provisioned unit on the member
switches. Here is the format of the command:
switch switch_ID provision
This example adds a provisioned switch to the current switch and assigns
it the ID 2:
sbx908gen2