Switch Provision Command - Allied Telesis CentreCOM GS970EMX/52 Installation Manual

Gigabit layer 3 lite access switches with 10 gigabit uplinks

Table of Contents

Chapter 10: Building Stacks with Multi-Gigabit Copper Ports

SWITCH

PROVISION

Command

132

You use this command to add member switches to the configuration of the

master switch before powering on the stack for the first time. Here are the

command guidelines:

Adding member switches to the master switch is not required when



using the default SFP+ S1 and S2 ports as the stack trunk.

Adding member switches to the master switch is required when



using the Multi-Gigabit copper ports as the trunk.

You have to add one provisioned member switch for each physical



member switch to be in the stack. For example, if the stack will

have three member switches, then you have to add three

provisioned switches to the master switch.

You can add only one member switch at a time with the command.



Here is the format of the command:

switch switch_ID provision GS970EMX-20|GS970EMX-28|

GS970EMX-52

This example adds a GS970EMX/20 Switch as a provisioned member

switch with the ID 2 to the master switch:

awplus(config)# switch 2 provision GS970EMX-20

This example adds a GS970EMX/28 Switch as a provisioned member

switch with the ID 3 to the master switch:

awplus(config)# switch 3 provision GS970EMX-28

This example adds a GS970EMX/52 Switch as a provisioned member

switch with the ID 4 to the master switch:

awplus(config)# switch 4 provision GS970EMX-52

Table of Contents