When changing communication interface setting by Utility
The communication interface setting can be changed by the Utility.
For details on the Utility, refer to the following manual.
GT
User's Manual
28.3.6 Verifying GOT recognizes connected equipments
1
After powering up the GOT, touch [Main
Menu]
[Communication setting] from
the Utility.
2
The [Communication setting] appears.
3
Verify that the following communication
driver name is displayed in the box for the
communication interface to be used.
• Communication driver
Bus (Q)
OMRON SYSMAC
OMRON THERMAC/INPANEL NEO
MELSERVO-J3,J2S/M
4
When the communication driver name is
not displayed normally, carry out the
following procedure again.
Section 28.3 Preparatory
Procedures for Monitoring
28.3 Preparatory Procedures for Monitoring
25
26
27
28
29
30
31
28 - 11