Figure 16-13 shows a block diagram of the watchpoint facility.
WP1_TRIGGER
WP1_MASK
WP2_TRIGGER
WP2_MASK
WP_CONTROL
wp_run
Figure 16-13. Watchpoint Facility Block Diagram
16.4 Watchpoint Trigger Applications
The watchpoint facility output trigger can be used by the system designer to initiate a halt
to the processor core through the checkstop signals. When the processor clock is stopped,
the internal state of the processor can then be scanned out through the JTAG port (TDO)
using emulators available from third party tool developers.
wp1_cnt
wp2_cnt
wp_control
Chapter 16. Programmable I/O and Watchpoint
Watchpoint Trigger Applications
Counter 1
=
Counter 2
=
MATCH1
=
MATCH2
=
Watchpoint
controller
TRIG_OUT
16-13