FUEL SYSTEM (PGM-FI)
ECT SENSOR
REMOVAL/INSTALLATION
Replace the ECT
Drain the coolant from the system (page 6-7).
sensor while the
Disconnect the 3P (Black) connector from the ECT
engine ,scold.
sensor.
Remove the ECT sensor and sealing washer.
Install a new sealing washer and ECT sensor.
Always replace a
sealing washer with
Tighten the ECT sensor to the specified torque.
anew one.
TORQUE: 23 N·m (2.3 kgf•m, 17 lbf•ft)
Connect the ECT sensor 3P (Black) connector.
Fill the cooling system with recommended coolant
(page 6-7).
BANK ANGLE SENSOR
REMOVAL/INSTALLATION
Remove the seat (page 2-4).
Disconnect the 3P (Green) connector.
Remove the screws. washers and bank angle sen
sor.
Installation is in the reverse order of removal.
Install rhe bank
angle sensor wilh
Tighten the mounting screws securely.
its
·up·· mark
facing up.
5-94
ECT SENSOR
... ...
$�
3P (Black) CONNECTOR
SEALING WASHER
BANK ANGLE SENSOR