FUEL SYSTEM (PGM-FI)
Turn the ignition switch ON and measure the volt
age between the terminals.
CONNECTION: Brown
There should be battery voltage for a few seconds.
If there is battery voltage a few seconds, replace the
fuel pump unit.
If there is no battery voltage, inspect the following:
-
main
- sub fuse 20A (Fl/Ignition)
- sub fuse 10A (Bank angle sensor)
- engine stop switch (page 20-21)
- fuel cut-off relay (page 5-58)
- engine stop relay (page 5-951
- bank angle sensor (page 5-94)
- ECM (page 5-96)
REMOVAL
Remove the fuel tank {page 5-58).
Remove the fuel pump unit mounting nuts and stay.
nor 10 Remove the fuel pump unit and packing.
Be careful
damage rhe pump
wire.
Remove the fuel pump chamber from fuel pump
unit.
5-56
(+)
-
Green
(-)
fuse
30A
2P (Black) CONNECTOR
(Wire side/female terminals)
Brown� Green
���
--=---.J
FUEL PUMP
CHAMBER