RONT WHEEUSUSPENSION/STEERING
Remove any burrs from the outer race installation
surface of the steering head.
Install
new lower outer race with the special tools
ote the installation
a
as shown.
d1rect,on of the
Hold the driver shaft with
ssembty base. the
A gradually until lower outer race is fully seated.
sma/11.D. side fac-
mg the upper
attachm e nt.
Install the removed parts in the reverse order of
CB600FA only.
removal.
LOWER INNER RACE REPLACEMENT
Temporarily install the steering stem nut onto the
stem to prevent the threads lrom being damaged
when removing the lower bearing inner race from
the stem.
Remove the lower bearing inner race with
or equivalent tool, being careful not to damage the
stem.
Remove the dust seal.
Apply grease to
over the steering stem.
Install a new lower bearing inner race using a spe
cial tool and a hydraulic press.
TOOL:
Steering stem driver
13-36
wrench and turn the nut
a
a
a
new dust seal lips and install it
07946-MB00000
ASSEMBLY
BASE
DRIVER
ATTACHMENT
- - - --.11
(upper)
...
.-
��
LOWER
OUTER RACE
DRIVER
ATTACHMENT
(lower)
LOWER INNER RACE
chisel
STEERING STEM NUT
... ...
��
LOWER INNER
RACE
NUT A
DRIVER SHAFT
DUST SEAL