Honda CB 600F Hornet 2007 Shop Manual page 215

SERVICE INFORMATION
GENERAL
Removing the radiator cap while the engine is hot can allow the coolant to spray out. seriously scalding you.
Always let the engine and radiator cool down before removing the radiator cap.
NOTICE I
Using coolant with silicate inhibitors may cause premature wear of water pump seals or blockage of radiator passages.
Using tap water may cause engine damage.
• Add cooling system at the reserve tank. Do not remove the radiator cap except to refill or drain the system.
• All cooling system services can be done with the engine in the frame.
• Avoid spilling coolant on painted surfaces.
• After servicing the system, check for leaks with a cooling system tester
• Refer to the ECT sensor inspection (page 20-15).
SPECIFICATIONS
ITEM
Coolant capacity
Radiator cap relief pressure
Thermostat
Recommended antifreele
Standard coolant concentration
TORQUE VALUES
Water pump assembly bolt
Water pump impeller bolt
Thermostat housing cover bolt
Radiator upper mounting bolt
Fan motor mounting bolt
Fan motor shroud mounting bolt
Radiator and engine
Reserve tank
Begin to open
I
Fully open
I
Valve lift
I
I
12 N•m (1.2 kgf,m, 9 lbf . ft)
12 N•m (1.2 kgf•m, 9 lbf,ft)
12 N-m (1 . 2 kgf-m, 9 lbf·ft)
3.5 N-m (0.4 kgf•m, 2.6 lbf-ftl
5.0 N•m (0.5 kgf-m, 3.7 lbf•ft)
8.4 N-m (0.9 kgf-m, 6.2 lbf•ft)
SPECIFICATIONS
2.90 liter (3.06 US qt, 2.55 Imp qt)
0.38 liter (0.4 US qt, 0.33 Imp qt)
108-137 kPa (1.1-1.4 kgf/cm', 16-20 psi)
80- 84 °C (176-183 °F)
95 °C (203 "F)
8 mm (0.3 in) minimum
High quality ethylene glycol antifreele containing corrosion
protection inhibitors
1:1 mixture with distilled water
CT bolt
CT bolt
COOLING SYSTEM
6-3