Honda CB 600F Hornet 2007 Shop Manual page 371

Mount the wheel, tire and brake disc (and pulser
ring; CB600FA) assembly on an inspection stand.
Spin the wheel, allow it to stop, and mark the lowest
(heaviest) part of the wheel with chalk.
Do this two or three times to verify the heaviest
area.
If the wheel is balanced, it will not stop consistently
in the same position.
To balance the wheel, install a balance weight on
the lightest side of the rim, on the side opposite the
chalk marks. Add just enough weight so the wheel
will no longer stop in the same position when it is
spun.
Do not add more than 60 g (2.1 oz) to the front
wheel.
NOTE:
• This model is equipped with a new shape bal­
ance weight made of zinc speller. This balance
weight is incompatible with the conventional one
in case of installation lo the wheel.
DISASSEMBLY
C8600FA only: Remove the torx bolts and speed sensor pulser ring.
Remove the bolts and brake discs.
Remove the dust seals.
FRONT WHEEL/SUSPENSION/STEERING
,,.,
•
�
DUST SEAL -.
•
___
� e e
13-17