Install the clutch center and thrust washer.
Install the lock washer with its "OUT" mark facing
out.
Apply engine oil to the threads and seating surface
of a new clutch center lock nut, then install it onto
the mainshaft.
Hold the clutch center with the special tool and
tighten the lock nut to the specified torque.
TOOL:
Clutch center holder
TORQUE: 128 N-m 113.1 kgf•m, 94 lbf . ftJ
careful not to Stake the lock nut into the mainshaft groove with a
Be
damage rhe punch.
meinsheft threads.
Install the spring seat and judder spring onto the
clutch center as shown.
CLUTCH/STARTER CLUTCH/GEARSHIFT LINKAGE
07724--0050002 or
equivalent commer
cially available
r
f
'
SPRING SEAT
JUDDER SPRING
.,
(
O .
'
•
-
'
• 1' <
�
-
9-15