Honda CB 600F Hornet 2007 Shop Manual page 389

Install the special tools into the steering head as
Note the mstaliat,on
shown and remove the lower outer race using the
direct10n of rhe
same procedure as for the upper outer race.
assembly base; the
large I. D. side
rile
facing lower
attachment.
Be careful nor to
bend or damage
the brake pipes
(C8600FA only).
Remove any burrs from the outer race installation
surface of the steering head.
Install a new upper outer race with the special tools
Note the 1nstsllat1on
as shown.
direct10n of the
Hold the driver shaft with a wrench and turn the nut
assembly base: the
1.0 A gradually until upper outer race is fully seated.
large side fac-
,ng the lower
attachment.
Be careful not to
bend or damage
the brake pipes
(C8600FA only/.
FRONT WHEEL/SUSPENSION/STEERING
DRIVER
ATTACHMENT
(upper)
BEARING
REMOVER 8
DRIVER
ATTACHMENT
(lower)
DRIVER
ATTACHMENT
(upper)
s
�
UPPER OUTER
RACE
DRIVER SHAFT
DRIVER SHAFT
NUT A
13-35