Ont Fe N Der - Honda CB 600F Hornet 2007 Shop Manual

Remove the cowl screws.
Carefully release the tabs of the right/left rear cowls
from the rear center lower cowl, then remove the
rear cowls.
Assembly is in the reverse order of disassembly.
While installi ng the
ligh c um t.
l
bra ke/ ta i
Tighten the cowl screws
roure the wir e
harness proper ty TORQUE: 4.0 N,m (0.4 kgf•m, 3 lbf•ft)
(pag9 1-23).
INSTALLATION
Install the rear cowl in the reverse order of removal.
Install the grab rails, collars and socket bolts B.
Install the washers and socket bolts A.
Tighten the socket bolts to the specified torque.
TORQUE: 27 N•m (2.8 kgf•m, 20 lbf,ft)
Install the seat (page 2-4).
FRONT FENDER
REMOVAL/INSTALLATION
Remove the front brake hose clamp cap nuts.
Remove the mounting bolts, washers and collars.
Release the front wheel speed sensor wire clip from
CB600FA only:
the sensor guide, then remove the sensor guide
from the front fender.
Remove the front fender forward.
Be careful not ro
scrat ch
the fron t
I ns a t II th
fender when
removal.
removmg1t
Tighten the front fender mounting bolts to the spec­
berween the franc
ified torque.
forks.
TORQUE: 12 N·m (1.2 kgf•rn, 9 lbf . ft)
-
to the specified torque.
•
e remove d pa s in rt th e reverse order of
FRAME/BODY PANELS/EXHAUST SYSTEM
REAR CENTER
LOWER COWL
'
•
RIGHT/LEFT REAR COWLS
SOCKET BOLT B/COLLAR
�1i
CAP NUTS
MOUNTING BOLTS
SCREWS
BOLT A/WASHER
FRONT FENDER
COLLARS
WASHERS
2-7