Honda CB 600F Hornet 2007 Shop Manual page 467

HYDRAULIC BRAKE
Install the boot into the caliper.
Install the pad spring onto the caliper body properly
as shown.
Apply silicone grease to the inside of the boots and
the slide pins.
Install the caliper bracket over the caliper body.
INSTALLATION
Install the rear brake caliper by aligning the caliper
bracket groove with the lug on the swingarm.
Install the rear wheel (page 14-13).
Connect the brake hose to the rear caliper with the
oil bolt and new sealing washers.
Push the stopper on the brake hose eyelet joint
against the caliper body, then tighten the oil bolt to
the specified torque.
TORQUE: 34 N-m (3.5 kgf•m, 25 lbf•ft)
Install the rear brake pads (page 15-19).
Fill and bleed the rear hydraulic system (page 15-
14).
15-48
PAD SPRING
BRACKET
.....,_,..
PAD SPRING
CALIPER BODY
BRACKET