Honda CB 600F Hornet 2007 Shop Manual page 344

r
CJ
Letters (A, B or
on the left side of
upper crankcase
are the codes for
the be,mng support
I D.s from left to
right.
Numbers (1. 2 or 3)
on the crank weight
are rhe codas for
the main journal
0 D.s from left to
righr
PLASTIC REGION TIGHTENING METHOD:
Install the crankcase 8 mm bolts (main journal 8 mm
bolts).
Loosely install all the crankcase bolts.
Make sure the upper and lower crankcase are
seated securely.
Tighten the crankcase 8 mm bolts (main journal
bolts) as follow:
Tighten the crankcase 8 mm bolts (main journal
bolts) in numerical order in the illustration in two to
three steps to the specified torque.
Further tighten the crankcase 8 mm bolts (main
journal bolts) 120-degrees.
TORQUE: 1 5 N•m (1.5 kgf•m, 11 lbf•ft) + 120
Remove the crankcase 8 mm bolts (main journal
bolts) and lower crankcase, measure the com­
pressed plastigauge at its widest point on each
main journal to determine the oil clearance.
SERVICE LIMIT: 0.05 mm (0.002 in)
If the oil clearance exceeds the service limit, select a
replacement bearing.
BEARING SELECTION
Record the crankcase bearing support I.D. code let­
ters from the pad on the left side of the upper crank­
case as shown.
Record the corresponding main journal O.D. code
numbers from the crank weight.
CRANKSHAFT /PISTON/CYLINDER
°
CRANKCASE 1.D. CODE
MAIN JOURNAL O.D. CODE
12-9