FRAME/BODY PANELS/EXHAUST SYSTEM
REAR FENDER
REMOVAL
Remove the following:
- rear cowl (page 2-6)
- battery (page 17-6)
- bank angle sensor (page 5-94)
- starter relay switch (page 19-16)
Remove the fuse boxes. fan control/fuel cut relays,
turn signal relay and engine stop/headlight relays
from the rear fender.
Release the option connector from the rear fender.
Slide the rubber boot off the connectors.
Disconnect the license light 2P (Natural). right rear
turn signal 2P (Light blue) and left rear turn signal
2P (Orange) connectors.
Release the seat lock cable from the cable guides.
Disconnect the seat lock cable from the seat lock key
cylinder.
Pull up the lock plate, then remove the seat lock key
cylinder from the rear fender.
2-8