Fuel Pump - Honda CB 600F Hornet 2007 Shop Manual

Jump the Brown and Black/white wire terminals of
the wire harness side using a jumper wire.
• Place an approved gasoline container and drain
the gasoline.
• Wipe off spilled out gasoline.
Disconnect the quick connect fitting from the fuel
joint (page 5-51 ).
Attach the hose attachment to the fuel joint.
TOOL:
Pressure gauge hose
attachment C
Turn the ignition switch ON for 10 seconds.
Measure the amount of fuel flow.
Amount of fuel flow:
189 cm
/10 seconds at 12 V
If the fuel flow is less than specified, inspect the
following:
- pinched or clogged fuel hose
- fuel pump unit (page 5-55)
Remove the hose allachm,mt from lhe fuel joi11l a"'J
connect the quick connect fitting (page 5-52).

FUEL PUMP

INSPECTION
Turn the ignition switch ON and confirm that the
fuel pump operates for a few seconds.
If the fuel pump does not operate, inspect as follow:
Turn the ignition switch OFF.
Lift and support the fuel tank (page 3-5).
Disconnect the fuel pump unit 2P (Black) connector.
07ZAJ-S7C0100
(6.4 US oz . . 6.7 Imp oz) minimum
3
FUEL SYSTEM (PGM-FI)
Black/white
f
RELAY TERMINALS
ATTACHMENT
�-------------------'
2P (Black) CONNECTOR
JUMPER WIRE
5-55