Honda CB 600F Hornet 2007 Shop Manual page 236

SERVICE INFORMATION
GENERAL
• A hoist or equivalent is required to support 'the motorcycle when removing and installing the engine.
• A floor jack or other adjustable support is required to support and maneuver the engine.
NOTICE I
Do not use the oil filter and oil cooler as a jacking point.
• The following components can be serviced with the engine installed in the frame.
- Alternator (page 10-4)
- Clutch (page 9-6)
- Starter clutch (page 9-17)
- Gearshift linkage (page 9-22)
- Camshaft (page 8-8)
- Oil cooler (page 4-14)
- Oil pump (page 4-8)
- Water pump (page 6-17)
- Cylinder head (page 8-12)
- Valves (page 8-18)
• The following components require engine removal for service.
- Crankshaft (page 12-5)
- Piston/cylinder (page 12-14)
- Shift fork/shift drum/transmission (page 11-6)
• When installing the engine, be sure to tighten the engine mounting fasteners to the specified torque in the specified
sequence. If you mistake the torque or sequence, loosen all mounting fasteners, then tighten them again to the speci­
fied torque in the correct sequence.
SERVICE DAT A
ITEM
Engine dry weight
Engine oil capacity (After disassembly)
Coolant capacity (Radiator and engine)
TORQUE VALUES
Front engine hanger nut
Front engine mounting bolt
Rear engine hanger nut
Rear engine mounting nut
Swingarm pivot bracket nut
Drive sprocket bolt
Starter motor terminal nut
Gearshift arm pinch bolt
2.90 liter (3.06 US qt, 2.55 Imp qt)
49 N•m (5.0 kgf-m, 36 lbf•ft)
59 N·m (6.0 kgf•m, 44 lbf·ft)
49 N-m (5.0 kgf•m, 36 lbf·ftl
59 N•m (6.0 kgf•m, 44 lbf•ft)
69 N•m (7.0 kgf•m, 51 lbf•ft)
54 N·m (5.5 kgf•m, 40 lbf•ft)
10 N·m (1.0 kgf•m, 7 lbf·ft)
20 N·m (2.0 kgf•m. 15 lbf·ft)
ENGINE REMOVAL/INSTALLATION
SPECIFICATIONS
57. 7 kg (127.2 lbs)
3.5 liter (3.7 US qt, 3.1 Imp qt)
7-3