FUEL SYSTEM (PGM-FI)
3. Oz Sensor Short Circuit Inspection
Connect the 02 sensor 4P (Black) connector.
Check for continuity between the ECM 33P (Light
gray) connector of the wire harness side and
ground.
CONNECTION: B20
TOOL:
Test probe
Is there continuity?
YES
NO
4. 02 Sensor Inspection
Connect the ECM 33P connectors.
Replace the 02 sensor with a known good one
(page 5-100).
Clear the ECM self-diagnosis memory data (page
5-14).
Start the engine and warm the engine up to cool
ant temperature is 80 •c ( 176 °F).
Test-ride the motorcycle and check the 02 sensor
with the HOS pocket tester.
Is the OTC 21-1 indicated?
YES
NO
DTC 23-1 (02 SENSOR HEATER)
• Before starting the inspection, check for loose or
poor contact on the 02 sensor 4P (Black) connec
tor and ECM 33P connectors, then recheck the
OTC.
1. Oz Sensor Heater System Inspection
Clear the ECM self-diagnosis memory data (page
5-14).
Start the engine and check the Oz sensor heater
with the HOS pocket tester.
Is the OTC 23-1 indicated?
YES
NO
5-32
-
Ground
07ZAJ-RDJA 110
- Short circuit in the Orange/white wire
- GO TO STEP 4.
- Replace the ECM with a known good
one, and recheck; refer to Key Registra
tion Procedures (page 21-6)
- Faulty original 02 sensor
- GO TO STEP 2.
- Intermittent failure
33P (Light gray) CONNECTOR
(Wire side/female terminal)
B20 TERMINAL