Remove the pad pin plug.
Remove the pad pin and brake pads.
Make sure that the pad spring is in place.
Always replace the Install the new brake pads.
brake p;;ds in p;;irs
Push the brake pads against the pad spring, then
to assure even disc
install the pad pin.
pressure.
Tighten the pad pin to the specified torque.
TORQUE: 17 N·m (1.7 kgf•m, 13 lbf . ft)
Install the pad pin plug and tighten it to the speci
fied torque.
TORQUE: 2.5 N·m (0.3 kgf•m, 1.8 lbf·ft)
Operate the brake lever to seat the caliper pistons
against the pads.
REAR BRAKE PAD REPLACEMENT
(CB600FA)
Check rhe brake Push the caliper piston all the way in to allow instal- _!"W....,.
lation of new brake pads by pushing the caliper
fluid level in the
reservoir as this body inward.
operat,on causes
the level 10
rise
HYDRAULIC BRAKE
15-17