Honda CB 600F Hornet 2007 Shop Manual page 305

CLUTCH/STARTER CLUTCH/GEARSHIFT LINK.AGE
INSTALLATION
Apply a locking agent to the stopper arm pivot bolt
threads.
Install the following:
- washer
- return spring
- stopper arm
- pivot bolt
Tighten the stopper arm pivot bolt to the specified
torque.
TORQUE: 12 N-m (1.2 kgf,m, 9 lbf•ft)
Install the dowel pin onto the shift drum.
Align the dowel pin Install the gearshift cam while holding the stopper
on the shih d1tJm arm using a screwdriver as shown.
whh the wide
groove on the
gearshih cam
Apply a locking agent to the shift drum center
socket bolt threads.
Tighten the socket bolt to the specified torque.
TORQUE: 23 N·m (2.3 kgf-m, 17 lbf•ft)
Install the thrust washer and gearshift spindle
assembly into the crankcase while aligning the
spring ends with the crankcase stopper pin.
9-24