REAR BRAKE PAD REPLACEMENT
(CB600F)
Push the caliper piston all the way in to allow instal
Check the brake
lation of new brake pads by pushing the caliper
flu1d level m the
as
body inward.
reservo,r
1h,s
operation causes
the level to r,se.
Loosen the pad pin.
Pull the pad pin out of the caliper body while hold
ing the brake pads.
Remove the brake pads.
Make sure that the brake pad spring is in place.
Install new brake pads into the caliper so their ends
Always replace the
rest into the pad retainer on the bracket properly.
brake pads
in
pairs
to assure even d,sc
pressure.
Coat the stopper ring on the pad pin end with the
silicone grease.
Install the pad pin by pushing in the pads against
the pad spring to align the pad pin holes in the pads
and caliper body.
HYDRAULIC BRAKE
•
- •
--'"'
-
15-19