Honda CB 600F Hornet 2007 Shop Manual page 103

LUBRICATION SYSTEM
Clean the oil pan mating surface thoroughly.
Apply sealant (Three Bond 12078 or an equivalent)
Oonorapplymore
to the mating surface.
sealant than
necessary.
Install the oil pan onto the lower crankcase.
Install the flange bolts.
Tighten the bolts in a crisscross pattern in two or
three steps.
Install the exhaust pipe (page 2-15).
Fill the crankcase with the recommended oil (page
3-15).
After installation, check that there are no oil leaks.
OIL PUMP
REMOVAL
Drain the engine oil (page 3-15).
Remove the following:
- right crankcase cover (page 9-5)
- oil pan/oil strainer (page 4-6)
Remove the bolt, washer and oil pump driven
sprocket.
Remove the bolts, oil pipe A and seal rings.
Clean the oil pipe A thoroughly.
4-8
SEAL RINGS
OIL PIPE A
C'