Honda CB 600F Hornet 2007 Shop Manual page 457

HYDRAULIC BRAKE
Remove the caliper pin boot from the caliper
bracket.
If the caliper pin boot is hard or deteriorated,
replace it with a new one.
Remove the pad spring and bracket pin boot from
the caliper body.
If the bracket pin boot is hard or deteriorated,
replace it with a new one.
Place a shop towel over the pistons.
Position the caliper body with the pistons facing
Do not use high
down and apply small squirts ot air pressure to the
pressure air or bring
the nozzle too close fluid inlet to remove the pistons.
to the inlet.
Be careful not ro Push the dust seals and piston seals in and lift them
out.
damage the p,sron
sliding surface.
Clean the seal grooves, caliper cylinders and pis­
tons with clean brake fluid.
15-38
CALIPER BRACKET
BOOT
BOOT
PAD SPRING
PISTON SEALS
DUST SEALS
CALIPER BODY