Honda CB 600F Hornet 2007 Shop Manual page 347

CRANKSHAFT /PISTON/CYLINDER
Tighten the nuts in two or three steps alternately,
then tighten the nuts to the specified torque.
TORQUE: 26 N·m (2.7 kgf·m, 19 lbf.ft)
Remove the bearing caps and measure the com­
pressed plastigauge at its widest point on the
crankpin to determine the oil clearance.
SERVICE LIMIT: 0.06 mm (0.002 in)
If the oil clearance exceeds the service limit, select
the correct replacement bearings.
BEARING SELECTION
Record the connecting rod I.D. code number (1 or 2)
Nvmoers /1 or 21 on
or measure the I.D. with the connecting rod bearing
the connecting rods
are the codes cap installed without bearing inserts.
!01
the connecting rod
I.D.
If you are replacing the crankshaft, record the corre­
Lerrers or BJ on
(A
rhe sponding crankpin O.D. code letter (A or 8).
crankwe,ght are
the codes fo1 the
If you are reusing the crankshaft, measure the
crankpm O.D.s
crankpin O.D. with the micrometer.
from left to right.
12-12
CONNECTING ROD I.D. CODE
CRANKPIN O.D. CODE