Honda CB 600F Hornet 2007 Shop Manual page 528

ELECTRIC STARTER
ST ARTER RELAY VOLT AGE
INSPECTION
Connect the starter relay switch 4P connector.
Shift the transmission into neutral.
Measure the voltage between the Yellow/red wire
terminal (+) and body ground(-).
If the battery voltage appears only when the starter
switch is pushed with the ignition switch ON and
engine stop switch
CONTINUITY INSPECTION
Disconnect the 4P connector, battery(+) cable and
starter motor cable from the starter relay switch.
Connect a fully charged 12 V battery positive wire to
the relay switch Yellow/red wire terminal and nega­
tive wire to the Green/red wire terminal.
Connect an ohmmeter to the starter relay switch
large terminals.
There should be continuity between the large termi­
nals when the battery is connected, and no continu­
ity when the battery is disconnected.
REMOVAL/INSTALLATION
Remove the seat (page 2-4).
Disconnect the starter relay switch 4P connector.
Remove the terminal bolts and disconnect the
starter relay switch cables.
Pull the starter relay switch out from the stay.
Installation is in the reverse order of removal.
19-16
"0",
it is normal.
e
Green/red
TERMINAL
CJ
Yellow/red
TERMINAL