Honda CB 600F Hornet 2007 Shop Manual page 397

SERVICE INFORMATION
GENERAL
• A contaminated brake disc or pad reduces stopping power. Discard contaminated pads and clean a contaminated disc
with a high quality brake degreasing agent.
• After the rear wheel installation, check the brake operation by applying the brake pedal.
• The shock absorber contains nitrogen under high pressure. Do not allow fire or heat near the shock absorber.
• Before disposal of the shock absorber, release the nitrogen (page 14-16).
• When servicing the rear wheel and suspension, support the motorcycle using a safety stand or hoist.
• Use only tires marked "TUBELESS" and tubeless valves on rim marked "TUBELESS TIRE APPLICABLE".
• Use genuine Honda replacement bolts and nuts for all suspension pivot and mounting point.
• Refer to the brake system information (page 15-4).
SPECIFICATIONS
ITEM
Minimum tire tread depth
Cold tire pres- Driver only
sure
Driver and passenger
Axle runout
Wheel rim
Radial
run out
Axial
Wheel balance weight
Drive chain Size/link
Slack
Shock absorber spring pre-load adjuster standard
position
TORQUE VALUES
Drive chain case mounting bolt
Rear axle nut
Rear brake disc mounting bolt
Driven sprocket nut
Shock absorber mounting nut
Swingarm pivot nut
Swingarm pivot bracket nut
Drive chain slider bolt
Rear pulser ring mounting bolt (CB600FA)
Footpeg holder mounting bolt
Rear brake hose guide screw
Rear brake fluid reservoir mounting bolt
290 kPa (2.90 kgf/cm', 42 psi)
290 kPa (2.90 kgf/cm', 42 psi)
I
DID DID525VM2-118LE
I
REG525ZRPB-118L
REGINA
-
30-40 (1-3/16-1-9/16)
f--Position 2
12 N-m (1.2 kgf•m, 9 lbf·ft)
98 N•m (10.0 kgf-m, 72 lbf·ft)
42 N·m (4.3 kgf•m, 31 lbf·ft)
108 N-m (11.0 kgf·m, 80 lbf·ft)
42 N-m (4.3 kgf-m, 31 !bf . ft)
98 N·m (10.0 kgf•m, 72 lbf·ft)
69 N•m (7.0 kgf•m, 51 lbf•ft)
9.0 N-m (0.9 kgf·m, 6.6 lbf·ft)
7. 0 N•m (0.7 kgf•m, 5.2 lbf·ft)
37 N•m (3.8 kgf•m, 27 lbf•ft)
4.2 N•m (0.4 kgf-m, 3.1 lbf·ftl
10 N·m (1.0 kgf•m, 7 lbf•ft)
REAR WHEEL/SUSPENSION
STANDARD
-
-
-
-
-
U-nut
ALOC bolt: replace with a new one.
U-nut
U-nut
ALOC bolt: replace with a new one.
ALOC bolt: replace with a new one.
Unit: mm (in)
SERVICE LIMIT
-
2.0 (0.08)
-
0.2 (0.01)
2.0 (0.08)
2.0 (0.08)
60 g
(2.1 oz) max.
-
-
-
-
-
14-3