Brake Fluid Replacement - Honda CB 600F Hornet 2007 Shop Manual

After there are no more air bubbles in the fluid,
repeat the air bleeding procedure about two or
three times at each bleed valve.
Make sure the bleed valves are closed and operate
the brake pedal. If it still feels spongy, bleed the sys­
tem again.
After bleeding the air completely, tighten the bleed
valves to the specified torque.
TORQUE: 5 . 4 N•m (0.6 kgf-m, 4.0 lbf . ft)
Fill the reservoir to the "UPPER" level with DOT 4
brake fluid.
Install the diaphragm, set plate and reservoir cap.
Install the reservoir onto the frame and tighten the
mounting bolt to the specified torque.
TORQUE: 10 N•m (1.0 kgf-m, 7 lbf-ft)
Install the right side cover (page 2-4).
BRAKE FLUID REPLACEMENT/AIR
BLEEDING (CB600F)
BRAKE FLUID DRAINING
Turn the handlebar to the left until the front master
Front brake:
cylinder reservoir is level before removing the res­
ervoir cap.
Remove the screws, reservoir cap, set plate and dia­
phragm.
Remove the right side cover (page 2-4).
Rear brake:
Remove the reservoir mounting bolt.
Remove the reservoir cap, set plate and diaphragm.
Secure the reservoir with the mounting bolt.
Connect a bleed hose to the brake caliper bleed
valve.
loosen the bleed valve and pump the brake lever/
pedal until no more fluid flows out of the bleed
valve.
HYDRAULIC BRAKE
15-13