Honda CB 600F Hornet 2007 Shop Manual page 100

OIL PRESSURE INSPECTION
01I Remove the rubber cap from the EOP switch.
ff ths pressure
indicator lighe
Remove the terminal bolt and disconnect the EOP
remains on while
switch wire.
,s
the engine
Remove the EOP switch while holding the switch
running, check the
base.
indicator system
beforB checking the
otl pressure.
Install the oil pressure gauge attachment to the
switch base.
Connect the oil pressure gauge to the oil pressure
gauge attachment.
TOOLS:
Oil pressure gauge set
Oil pressure gauge attach­
ment
Check the oil level and add the recommended oil if
necessary (page 3-15).
Warm the engine to normal operating temperature
(approximately 80
speed to 6,000 min•• (rpm) and read the oil pressure.
OIL PRESSURE:
496 kPa (5.1 kgf/cm
(ao
0
cI11s
Stop the engine and remove the tools.
Apply a sealant to the EOP switch threads as shown.
07506-3000001 or
equivalent
commercially avail•
able
07510-4220100 or
equivalent
commercially avail-
able
C/176 F) and increase the engine
° °
2 • 72 psi) at 6,000 min•• (rpm)/
° Fl
LUBRICATION SYSTEM
Do not apply to the thread head
3 - 4 mm (0.1 - 0.2 in)
l
EOPSWITCH
4-5