Engine Oil Pressure Indicator; Eop Switch - Honda CB 600F Hornet 2007 Shop Manual

LIGHTS/METER/SWITCHES
Turn the ignition switch to "ON" and check the
engine coolant temperature and warning indicators.
• If the engine coolant temperature and warning
indicators light as over heat (shown in the right
illustration), inspect the ECT sensor (page 20-16).
• If the engine coolant temperature and warning
indicators do not tight, check the following.
- Open circuit in the ECT sensor (Green/blue)
wire
- Faulty combination meter
ECT SENSOR INSPECTION
Remove the ECT sensor (page 5-94).
Suspend the ECT sensor in a pan of coolant (1 :1
mixture) an electric heating element and measure
the resistance through the sensor as the coolant
heats up.
• Soak the ECT sensor in coolant up to its threads
with at least 40 mm (1.6 in) from the bottom of
the pan to the bottom of the sensor.
• Keep the temperature constant for 3 minutes
before testing. A sudden change of temperature
will result in incorrect readings. Do not let the
thermometer or ECT sensor touch the pan.
Replace the sensor if it is out of specification by
more than 10% at any temperature listed.
Temperature
Resistance
Install the ECT sensor (page 5-94).

ENGINE OIL PRESSURE INDICATOR/

EOP SWITCH

INSPECTION
If the engine oil pressure and warning indicators
stay on while the engine running in spite of the nor­
mal engine oil condition and level, check the follow­
ing.
20-16
80"C (G8"F)
12o·c (248"Fl
2.1 - 2.6 kn
0.65 - 0. 73 kU
WARNING INDICATOR
'"
\./,
/ D
\�,.)
E'-
'�\'
_::
ENGINE COOLANT
TEMPERATURE INDICATOR
ECT SENSOR
ECT SENSOR TERMINAL
ENGINE OIL PRESSURE -
INDICATOR