Honda CB 600F Hornet 2007 Shop Manual page 329

CRANKCASE/TRANSMISSION
Assemble the transmission gear and shafts.
• Coat each gear with clean engine oil and check
for smooth movement.
• Align the lock washer tabs with the spline
washer grooves.
• Always install
with the chamfered {rolled) edge facing away
from the th rust load.
• Install the snap ring so that its end gap aligns
with the groove of the splines.
• Make sure that the snap ring is fully seated in the
shaft groove after Installing it.
11-12
the thrust washer and snap ring
CORRECT
INCORRECT
SNAP RING