Honda CB 600F Hornet 2007 Shop Manual page 461

HYDRAULIC BRAKE
DISASSEMBLY
Remove the slide pin boot from the caliper bracket.
If the boot is hard, damaged or deteriorated, replace
it with a new one.
Remove the pad spring, collar and bracket pin boot
from the caliper body.
If the boot is hard, damaged or deteriorated, replace
it with a new one.
Place a shop towel over the piston.
Position the caliper body with the piston facing
Do not use h,gh
down and apply small squirts of air pressure to the
pressure a,r or bong
fluid inlet to remove the piston.
the nozzle too close
the inlet.
Push the dust seal and piston seal in and lift them
Be careful not to
out.
damage the piston
sliding surface.
Clean the seal grooves, caliper cylinder and piston
with clean brake fluid.
15-42
COLLAR
CALIPER BODY
PAD SPRING
PISTON SEAL
DUST SEAL
BOOT