S Er V I Ce I N F O R M A Tio; Troubleshooting - Honda CB 600F Hornet 2007 Shop Manual

SE RV I CE IN FO RM A TI O N
GE NER AL
• wor k in a well ventilated
ca us e a fir e or ex plo sio n.
• Thi s section covers removal and installation
• Seriou s burns may result if the exhaust system is not allowed to cool before components are removed or serviced.
• Alway s replace the exhaust pipe gaskets after removing the exhaust pipe from the engine.
• Whe n install i ng the exhaust system, loosely install all of the exhaust pipe fasteners. Always tighten the exhaust clamps
first, then tighten the mounting fasteners. If you tighten the mounting fasteners first, the exhaust pipe may not seat
prope rl �
• Always inspect the exhaust system for leaks after 1nstallat1on .
TORQUE VALUES
Exhaust pipe joint nut
Exhaust pipe/muffler mounting nut
Exhaust pipe/muffler protector socket
bolt
Muffler band bolt
Grab rail socket bolt
Rear center lower cowl screw
Front fender mounting bolt
Side cover socket bolt
Seat rail upper mounting nut
Seat rail lower mounting bolt
Delay valve mounting bolts
Rear brake fluid reservoir mounting bolt

TROUBLESHOOTING

Excessive exhaust noise
• Broken exhaust system
• Exhaust gas leak
Poor performance
• Deformed exhaust system
• Exhaust gas leak
• Clogged muffler
area. Smoking or allowing flames or sparks in the work area or where gasoline is stored can
of the body panels and exhaust system.
.
12 N•m (1.2 kgf•m, 9 lbf·ft)
22 N•m (2.2 kgf•m, 16 lbf•ft)
12 N•m (1.2 kgf•m, 9 lbf . ft)
22 N•m (2.2 kgf•m, 16 lbf,ft)
27 N·m (2.8 kgf·m, 20 lbf•ft)
4.0 N-m (0.4 kgf•m, 3 lbf•ft)
12 N•m (1.2 kgf•m, 9 lbf . ft)
4.0 N·m (0.4 kgf·m. 3 lbf·ft)
39 N•m (4.0 kgf-m, 29 lbf•ft)
39 N·m (4.0 kgf·m, 29 lbf·ft)
12 N·m (1.2 kgf·m, 9 lbf·ft)
10 N•m (1.0 kgf·m, 7 lbf·ft)
FRAME/BODY PANELS/EXHAUST SYSTEM
.
2-3