Honda CB 600F Hornet 2007 Shop Manual page 98

SERVICE INFORMATION
GENERAL
Used engine oil may cause skin cancer if repeatedly left in contact with the skin for prolonged periods. Although this is
unlikely unless you handle used oil on a daily basis, it is still advisable to thoroughly wash your hands with soap and
water as soon as possible after handling used oil.
• The oil pump can be serviced with the engine installed in the frame.
• The service procedures in this section must be performed with the engine oil drained.
• When removing and installing the oil pump, use care not to allow dust or dirt to enter the engine.
• If any portion of the oil pump is worn beyond the specified service limits, replace the oil pump as an assembly.
• After the oil pump has been installed, check that there are no oil leaks and that oil pressure is correct.
SPECIFICATIONS
�
Engine oil capacity
Engine oil
Oil pressure at EOP switch
Oil pump
TORQUE VALUES
Engine oil drain bolt
Engine oil filter cartridge
Oil filter boss
Oil pump driven sprocket bolt
Oil pump assembly bolt
Oil cooler bolt
EOP switch
EOP switch wire terminal bolt
Oil pipe A mounting bolt
ACAUTION
ITEM
After draining
After oil filter change
After disassembly
-
Tip clearance
Body clearance
Side clearance
30 N•m (3.1 kgf•m, 22 lbf•ft)
26 N•m (2.7 kgf-m, 19 lbf,ft)
See page 3-15
15 N•m (1.5 kgf•m, 11 lbf·ft)
12 N•m (1.2 kgf•m, 9 lbf•ft)
59 N-m (6.0 kgf•m, 44 lbf·ft)
12 N·m (1.2 kgf•m, 9 lbf•ftl
2.0 N•m (0.2 kgf•m, 1.5 lbf•ft}
12 N•m (1.2 kgf•m, 9 lbf•ftl
STANDARD
2.7 liter (2.9 US qt, 2.4 Imp qt)
2.8 liter (3.0 US qt, 2.5 Imp qt)
3.5 liter (3.7 US qt, 3.1 Imp cit)
Suggested oil:
Honda "4-stroke motorcycle oil" or
an equivalent
Oil recommendation:
API classification: SG or higher
(except oils labeled as energy con-
serving on the circular API service
label)
Viscosity: SAE 10W-30
JASO T 903 standard: MA
496 kPa (5.1 kgf/cm', 72 psi) at
°
6,000 min•' (rpm)/(80 C/176
0.15 (0.006)
0.15- 0.21 (0.006- 0.008)
0.04 - 0.09 (0.002 - 0.004)
Apply engine oil to the threads and O-ring.
Apply locking agent to the threads.
Apply a locking agent to the threads.
CT bolt
Apply engine oil to the threads.
Apply sealant to the threads.
Apply a locking agent to the threads.
LUBRICATION SYSTEM
Unit · mm (in)
-
SERVICE LIMIT
-
-
-
-
°
F)
0.20 (0.008)
0.35 (0.014)
0.17 (0.007)
4-3