Ect Sensor - Honda CBR650F Service Manual

dummyhead dummyhead
PGM-FI SYSTEM

ECT SENSOR

REMOVAL/INSTALLATION
Drain the coolant (page 8-4).
Remove the cam chain tensioner lifter (page 10-20).
Disconnect the ECT sensor 2P (Blue) connector [1].
Remove the ECT sensor [2] and O-ring [3].
Installation is in the reverse order of removal.
• Replace the O-ring with a new one (do not apply oil).
TORQUE:
ECT sensor: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Fill and bleed the cooling system (page 8-4).
IAT SENSOR
REMOVAL/INSTALLATION
Lift the fuel tank and support it (page 3-4).
Disconnect the IAT sensor 2P (Black) connector [1].
Remove the screws [2] and IAT sensor [3].
Remove the O-ring [4] from the IAT sensor.
Installation is in the reverse order of removal.
• Replace the O-ring with a new one and coat it with
the engine oil.
TORQUE:
IAT sensor screw: 1.1 N·m (0.1 kgf·m, 0.8 lbf·ft)
VS SENSOR
REMOVAL/INSTALLATION
Remove the bolt [1] and VS sensor [2].
Disconnect the VS sensor 3P (Black) connector [3] and
remove the O-ring [4] from the VS sensor.
Installation is in the reverse order of removal.
• Replace the O-ring with a new one and coat it with
engine oil.
• Install the O-ring into the groove in the VS sensor.
TORQUE:
VS sensor bolt: 12 N·m (1.2 kgf·m, 9 lbf·ft)
4-38
[1]
[2]
[1]
[2]
[3]
[1]
[2]
[3]
[4]
[3]
[4]