IMMOBILIZER SYSTEM (HISS)
CKP SENSOR LINE INSPECTION
Disconnect the CKP sensor 2P (Red) connector.
Check the Yellow wire for continuity between the
ECM and CKP sensor connectors.
Also check the White/yellow wire for continuity
between the ECM and CKP sensor connectors
There should be continuity between the same color
wire terminals.
IMMOBILIZER RECEIVER
Remove the headlight unit (page 20-6).
Disconnect the immobilizer receiver 4P (Natural)
connector.
Perform the following inspections at the wire har
ness side connector.
POWER INPUT LINE INSPECTION
Measure the voltage between the Yellow/red wire ,-----------------�
terminal (+) and ground(-).
There should be approx. 5 v when the ignition
switch is turned to "ON".
GROUND LINE INSPECTION
Check for continuity between the Green/orange wire
terminal and ground.
There should be continuity at all times.
21-14
w
33P (Black)
33P (Light gray)
CONNECTOR A (Wire
CONNECTOR B (Wire
side/female terminals)
side/female terminals)
4P (Natural) CONNECTOR
(Wire side/female terminals)
Yellow/red
,-----------------�
4P (Natural) CONNECTOR
(Wire side/female terminals)
Green/orange
2P (Red)
CONNECTOR
(Wire side/male
terminals)
\
--