Ect Sensor; Bank Angle Sensor - Honda CBF600SA Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
FUEL SYSTEM (PGM-FI)

ECT SENSOR

REMOVAL/INSTALLATION
Drain the coolant from the system (page 6-7).
Replace the ECT
sensor while the
Disconnect the 3P (Black) connector from the ECT
engine is cold.
sensor.
Remove the ECT sensor and sealing washer.
Install a new sealing washer and ECT sensor.
Always replace a
Tighten the ECT sensor to the specified torque.
sealing washer with
a new one.
TORQUE: 23 N·m (2.3 kgf·m, 17 lbf·ft)
Connect the ECT sensor 3P (Black) connector.
Fill the cooling system with recommended coolant
(page 6-7).

BANK ANGLE SENSOR

REMOVAL/INSTALLATION
Remove the rear cowl (page 2-5).
Disconnect the 3P (Green) connector.
Remove the screws, washers and bank angle sen-
sor.
5-94
email: info@motomatrix.co.uk
3P (Black) CONNECTOR
SEALING WASHER
3P (Green) CONNECTOR
BANK ANGLE
SENSOR
SCREWS/WASHERS
ECT SENSOR