Honda CB 600F Hornet 2007 Shop Manual page 108

l
Install the oil pump assembly onto the crankcase
while aligning the oil pump shaft lug with the water
pump shaft groove by turning the oil pump shaft.
Tighten the bolts securely.
Apply engine oil to new seal rings and install them
onto the oil pipe A.
Apply a locking agent to the oil pipe A mounting
bolt threads.
Install the oil pipe A and tighten the bolts in the
order as shown.
TORQUE: 12 N•m (1.2 kgf•m, 9 lbf•ft)
• First tighten the No.1 bolt, then tighten the No.2
bolt.
Apply engine oil to the oil pump driven sprocket
teeth and drive chain
Install the diiven sprocket with its "OUT" mark fac•
ing out.
Apply a locking agent to the oil pump driven
sprocket bolt threads.
Install and tighten the driven sprocket bolt/washer
to the specified torque.
TORQUE: 15 N•m (1.5 kgf•m, 11 lbf•ft)
Install the following:
- oil pan/oil strainer (page 4-7)
- right crankcase cover (page 9-25)
After installation, fill the crankcase with the recom­
mended oil (page 3-15).
Check the oil pressure (page 4-5).
Check that there is no oil leaks.
LUBRICATION SYSTEM
4-13