Vs Sensor - Honda CB 600F Hornet 2007 Shop Manual

VS SENSOR

-
SYSTEM INSPECTION
Check that the indicators function properly.
If they do not function, perform the power and
ground line inspection of the combination meter
(page 20-12).
Remove the meter cover (page 2-5).
Remove the dust cover.
Support the motorcycle securely using a safety
stand or hoist, and raise the rear wheel off the
ground.
Shift the transmission into neutral and turn the igni-
tion switch ON.
Measure the voltage between the Pink/blue (+) and
Green/black (-) wire terminals of the wire harness
side connector.
Slowly turn the rear wheel by hand.
There should be Oto 5 V pulse voltage.
• If pulse voltage appears, replace the combination
meter circuit board (page 20-10).
• If pulse voltage does not appear, check for open
or short circuit in the Pink/blue and Green/black
wires.
If the wire are OK, check the VS sensor (page 20-
13).
VS SENSOR INSPECTION
Remove the air cleaner housing (page 5-61 ).
Disconnect the VS sensor 3P (Black) connector.
Turn the ignition switch to ON and measure the
voltage between the Yellow/red (+) and Green/black
(-) wire terminals at the harness side 3P connector.
CONNECTION: Yellow/red (+) - Green/black (-)
STANDARD: Battery voltage
There should be battery voltage.
If there is no voltage, check for open circuit in
related wires.
If the speedometer does not operate, check the
speedometer inspection (page 20-12).
Then check the VS sensor power line inspection.
If the speedometer and wire harness between the
speedometer and VS sensor are normal, replace the
VS sensor (page 20-14).
LIGHTS/METER/SWITCHES
Viewed from harness side/
the 20P connector:
. .
.. Wire side/female
.
..
•
terminals:
I
' '
•
t( . •
'
-,
'
-
•.,-;;;,,-
-:
.....
·,
/r�-
_..., :..
·�-jj
••
=;:ia -
•
J I
-:" '- �
.
�
- _:a . J
•
- -
•
.
� , / ·I .,..,..,_
._J .
• ••
' ,· • ·
. I
.
-- ... , ) <":
>2
.
.
· · . • • ·r�.�:
>
;....,
I @
1/·P. .
•
.
_:�
, \ \
:..,.._ :-,-..
::-
,.
'"la'
Yellow Green
20-13